Fermzilla 27L Tri-Conical Starter Kit

Fermzilla 27L Tri-Conical Starter Kit

Starter kit including pressure kit, overpressure valve and dip tube filter

FermZilla Tri Conical Gen 3 is the first PET fermentation tank on the market with Tri-Clamp couplings. In comparison to the previous generation, this will make disconnection extremely much easier, especially when it comes to cleaning! (see video below)

FermZilla 27L Tri-Conical is made for pressurized fermentation and will provide you with a completely oxygen-free fermentation with the right accessories.

The FermZilla series has revolutionized the homebrew market with its PET fermentation vessels, which give you the same excellent fermentation conditions that a real brewery can have without costing both the shirt and the tie! Fermentation under pressure has really become available to everyone, and those who start with it never go back. This fermentation tank is designed for pressures up to 2.4 bar, which means that it can also be nicely used to serve from, like a real unitank.

The new model was designed by Kegland based on customer feedback. A recurring theme from the previous model was that it was too complicated to unscrew for cleaning. This has been totally changed with the new model!

FermZilla Tri-Conical can be used with a number of additional equipment, such as overpressure valve, pressure kit, hop bong kit, thermowell, temp twister cooling coil and much more. See recommended accessories further down the page.

Included:

1 pcs 27L Gen 3 Tri-Conical Tank with Tri-Clamp dump valve

1 pc FermZilla Red Plastic Pressure Kit

1 pc Ball lock with blowtie overpressure valve

1 pc Floating Dip Tube Filter

1 pc Standard FermZilla lid with red safety valve (2.5bar/35psi)

1 pcs Yeast lock

1 pcs stainless steel handle

1 pc 1000ml yeast collector

1 pcs stainless steel stand
1 pcs stick-on thermometer and liter marking
1 piece spare pack for lid and yeast collector

IMPORTANT:

Before use, carefully read the instructions for use. 
PET fermentation tanks must not be exposed to direct sunlight.
Never add liquid above 35°C to PET fermentation vessels.

When used under pressure:Before use,
a leak check should always be performed. This is simply performed by filling the tank with water and pressurizing with a minimum of 1 bar (15 psi). Check carefully for leaks at all connections by turning the fermentation tank where there is a risk of leakage.

Note that the fermentation tank may come delivered with small dents from transportation. This is unproblematic as it is designed with enough flexibility to withstand this. It will simply straighten out by fermentation under pressure.